Parameter bindings
A Binding Graph calculates the live value for one writable parameter. Use it for motion, audio response, remapping, smoothing, or a relationship between controls.
Open the graph for a parameter
Section titled “Open the graph for a parameter”- Right-click the parameter you want to drive.
- Select Open Binding Graph.
The graph opens with that parameter as its target. Add a source such as Time, add generator or processing nodes such as Sine or Smooth, then connect the result to the target. You can also drag another parameter’s pin directly to the target pin. If the target already has a graph, the new source is added to that graph so you can decide how to wire it into the existing logic.
This graph smooths a live Source before sending the result to the target.
Open the graph image for a full-size view.
Build motion with fewer nodes
Section titled “Build motion with fewer nodes”Search the Binding Graph palette for these nodes and connect their Value output to the target:
- Value Mixer moves through a list of values with Sine, Triangle, Saw, Smooth Noise, Step, or Random Step motion. Add or remove values on the node. Rate runs it freely; a wired Phase sets its position directly.
- Step Sequencer plays an editable value pattern. Ticks sets how long each step lasts. Rate sets ticks per second, or a wired Clock advances one tick on each rising pulse. Hold, Linear, and Smooth transitions apply to the internal clock; a wired Clock holds each step.
- Envelope turns a trigger into an attack, decay, sustain, and release shape. One Shot releases after its Hold time; Gate releases when the trigger falls.
- Drift makes repeatable, bounded movement around a Center. Set Amount, Rate, Return, and Seed to control its span and character.
- Signal Conditioner shapes an incoming scalar or vector with Gain, Bias, Deadzone, and Curve, then smooths rises and falls independently.
Editing these controls is part of the target’s Binding Graph. Save the project to keep the pattern and settings.
See and manage connections
Section titled “See and manage connections”Press W to show parameter connections in Studio. A driving connection has a small capsule on the cable; click it to open the receiving parameter’s Binding Graph and focus that source. Dragging the capsule gives the cable a temporary bend while you inspect crowded wiring, then the cable returns to its normal route when you release it.
Thin reference cables show where a graph reads another visible parameter. They are visual guides only: they do not make that source writable or driven.
To return the target to manual control, right-click the parameter or the cable capsule and choose Clear Target Binding. ZoneQ restores the saved manual value and leaves bindings for other targets alone.
